How to Remove Rust from Bike with Wd40?

The other day I was looking through my garage for my old bike – just wanted to take it out for cycling during my vacation. And quite expectedly, it was all rusty.

Now, I started searching for it with the mindset that I will have to take some time to clean it. And after thorough research, I found out that the best way to do that is to use WD-40.

But of course, you won’t get the best results if you don’t use it properly. Hence, we will be discussing how to remove rust from bike with WD40 right here!

What Is WD-40?

One of the most effective products for cleaning tough spots, removing rust, or paint is WD-40. And you have surely heard its name at least once whether or not you have a bike.

WD-40 is most often found in a blue and yellow can, and those cans can last up to 2000 sprays! So, this product is rather economical. Not to mention, they are mostly used for protecting metal against rust and corrosion.

Hence, if you have automobiles, then this is one of the must-haves in your shelf – their benefits will exceed your expectations, which we will discuss below.

Benefits of WD-40

If you don’t already have a WD-40, then you might think if getting one at this point is actually worth it or not. Hence, we will be discussing the benefits that you will get from one right here.

• Removes Rust

The primary benefit of WD-40 is that it removes rust from any metallic surface effortlessly – so your bike will be rust-free.

• Lubricates

Inefficient bike chain? WD-40 will fix that by lubricating it properly. In fact, this product can lubricate the locks on the bike racks as well.

• Cleans

But lubricating your bike chain is not all that’s needed – so WD-40 cleans it as well.

• Prevents Rust

Aside from removing rust, WD-40 does a very good job at preventing them – especially when you spray them on bike scratches.

WD-40 creates a water resistant coat that helps to prevent rust from forming. This is especially beneficial when your bike is not in use, as rain can easily cause oxidation and rusting.

• Prevents Dirt from Sticking

Spray it once, and no mud or dirt will stick to your bike.

Read More about Bike Care: Will My Bike Rust in the Rain?

How to Remove Rust from Bike Using WD-40?

Now that you know all about the WD-40, it is time to put it to use. Hence, we will be discussing how we should remove rust from your bike using this.

• Coat the Bike

The first step is to coat your bike thoroughly using the WD-40. Make sure to not miss any spots because the chances of the rust spreading are quite high. So start by the rear of the bike and eventually go to the front, while making sure that you have covered all the areas.

• Use a Plastic Wrapping

Once you have coated your bike with the WD-40, you need to keep it on for 10 minutes minimum. Instead of keeping the bike bare, coat it using plastic wrapping. So the WD-40 coating will soften the rust as it is wrapped up in plastic.

• Brush the Rust Away

After 10 minutes, open the plastic wrap and start brushing the bike. You can use wire or steel brushes for the purpose, but softer brushes will also do the trick if you want to avoid the chances of your bike getting scratched.

• Wipe Once You Are Done

After you have brushed your bike and removed all the rust from it, wipe off the bike. For this, you can use a piece of clothing or anything clean that can remove the excess rust and dirt from the surface of the bike.

You can also read: How to Fix a Bike Bell?

Final Words

Removing rust from your bike is a lot easier than always protecting it – and WD-40 makes it even more effortless.

Hopefully, once you learn how to remove rust from bike with WD40, your bike will be as good as brand new.